Siemens FT2080

Commands with required access levels
6
'Maintenance' command group
161
Building Technologies A6V10380629_en--_a
Fire Safety 2015-09-10
6.6 'Maintenance' command group
Command Element category (short) Element category (long) Access level
Reset module Module Module 3
Accept replaced devices Line Line 3
Device replace mode ON Detect. Detector 2.2
Device replace mode OFF Detect. Detector 2.2
Read in installed devices Line Line 3
Remove/delete device Detect. Detector 3
Restart line Line Line 2.2
Auto-configure line Line Line 3
Calibrate Module Module 3
Enable sys.analyzer access ↑ Station Station 3
Disable sys.analyz. access Station Station 3
Enable MC link Station Station 2.2
Disable MC link Station Station 2.2
Remove loop extension Module Module 3
Enable full access Si.View SintesoView 2.2
Enable view access Si.View SintesoView 2.2
Disable access Si.View SintesoView 2.2
Delete event memory Station Station 3
Factory reset Station Station 3
Poll diagnostic data Line Line 2.2
Release FSD FSD FSD 3
Reset maintenance reminder Station Station 3
Scan for new modules Station Station 2.2
Re-address devices Line (AnalogPLUS) Line (AnalogPLUS) 3
Stub line forward Line (AnalogPLUS / interactive) Line (AnalogPLUS / interactive) 3
Stub line backward Line (AnalogPLUS / interactive) Line (AnalogPLUS / interactive) 3
No. of devices
forward/backward
Line (AnalogPLUS) Line (AnalogPLUS) 3
Accept Sinteso Mobile client Client Sinteso Mobile client 2.2
Remove Sinteso Mobile client Client Sinteso Mobile client 2.2
Show site ID Station Station 3
Lock FSD FSD FSD 3
Switch over CPU Module Module 3
Enable MC mode Device Device 2.2
Disable MC mode Device Device 2.2
Enable raw data logging, set 1 Device Device 3
Enable raw data logging, set 2 Device Device 3
Enable raw data logging, set 3 Device Device 3
Disable raw data logging Device Device 3