Fundamentals of operation
4
Log in / Change access level
79
Building Technologies A6V10380629_en--_a
Fire Safety 2015-09-10
4.2 Log in / Change access level
WARNING
To prevent unauthorized access to the fire detection system, you must always log
out after working on the FT2080. See Log out / Block access level [➙ 82].
You can enable an 'Access level' by entering your 'PIN' in the PIN entry dialog
window. Alternatively you can use the key switch (optional) to release an Access
level.
If you press a key on the Person Machine Interface whose function requires a
higher 'Access level', the PIN entry dialog window is displayed automatically.
Without an 'Access level', the Access level 1' is enabled after executing the PIN
entry dialog window.
Enabling 'Access level' without a PIN
It makes no sense to use the '
' without entering a PIN, since '
level 1' is retained. All buttons on the general toolbar (GTB) re-open the PIN entry
dialog window.
w An 'Access level' is not enabled.
1. Press any button except 'Login/logout' on the general toolbar (GTB).
a The PIN entry dialog window called 'Login/logout' opens.
2. Press 'Enter'.
To Next Page
Loading...
Need help?
General
