Structure and function of the FT2080
3
Buttons, LEDs, and key switches
17
Building Technologies A6V10380629_en--_a
Fire Safety 2015-09-10
<Alarm device>
Deactivates the ↑ alarm devices in the event of alarm (password required).
Configurable standard buttons
The configurable standard buttons may be assigned with customer-specific
functions. You will find more information about configuring the standard buttons in
document '009078'.
3.2.2 LEDs
The LEDs on the ↑Person Machine Interface signal 'Events' and conditions. In
addition, the LEDs support the operator's orientation. The LEDs can light up in red,
yellow, or green. The LEDs can be configured according to customer-specific
requirements.
The LED colors can, for example, signal the following information:
Red l ALARM
l Activations, e.g., ↑remote transmission, ↑alarm
devices, control function
Yellow l Fault
l Isolation
l Deactivation, e.g. remote transmission, alarm devices,
control function
Green l System is in operation
Additional information on the conditions of the LEDs (steady on, steady off or
flashing) can be found in the relevant chapter.
3.2.3 Key switch (optional)
You can use the key switch to release an access level. The accessible access level
is configurable.
The key switch has 2 positions:
l On (horizontal position)
l Off (vertical position)
To Next Page
Loading...
Need help?
General
