Siemens M20 Terminal User Manual

AT command interface
Version 8 dated 15.03.00 40
Siemens Information and Communication Products
A
ATS0 Set number of rings before automatically answering the call
Read command
ATS0?
Response
<n> OK
Set command
ATS0=<n>
Response
This parameter setting determines the number of rings before automatic answering.
OK
Parameter
<n> 0 automatic answering is disabled
1-255 enable automatic answering on the ring number specified
Reference
V.25ter
Note
ATS2 Set Hayes ESC character
Read command
ATS2?
Response
<n> OK
Set command
ATS2=<n>
Response
This parameter setting determines the characters used in Hayes ESC sequence.
OK
Parameter
<n> 1-43-127Hayes escape character
Note:
default 43 = +
Reference
V.25ter
Note
ATS3 Set command line termination character
Read command
ATS3?
Response
<n> OK
Set command
ATS3=<n>
Response
This parameter setting determines the character recognized by TA to terminate an incoming com-
mand line.
OK
Parameter
<n> 0-13-127 command line termination character
Note:
default 13 = CR
Note:
Using other value than 13 may cause problems when entering commands
Reference
V.25ter
Note

Siemens M20 Terminal Specifications

General

Brand	Siemens
Model	M20 Terminal
Category	Engine
Language	English