Electrical connections
164 NXAIR / ≤ 40 kA 110-0084.9 / 15
Connect one single cable each with a cable sealing end. Connect one cable sealing end each
with a cable lug.
Lay the components of the floor cover into the bottom pan. While doing so, insert the rubber
sleeve in the floor cover.
Bolt the components of the floor cover together using the connecting elements (1) and (2).
Fig. 234: Assembly of the floor cover
12 bolts size M8x20
plus plain washers
size 8 acc. to ISO 7093
Insert the cable bracket (1), and put it in position.
Fasten the cable bracket using the connecting elements (2).
Fig. 235: Assembly of the cable bracket
4 bolts size M8 plus
plain washers size 8
acc. to ISO 7093
Fasten the cable to the cable bracket underneath the heat-shrinkable splitting cap; use a clamp.
To Next Page
Loading...
