Siemens NXAIR - Page 179

Closing the connection compartment / connection duct
110-0084.9 / 15 NXAIR / ≤ 40 kA 179
Fig. 255: 15 bolted joints on partition
Install the protection plate of the switching-device compartment (4) in the switching-device
compartment.
To fix the protection plate of the switching-device compartment (4), tighten the nuts (5) hand-
tight.
• 4 nuts M8 with contact washers
Tighten the fixing nuts (5) with a tightening torque of 25 Nm.
Fig. 256: 4 bolted joints on protection plate of switching-device compartment
If required, bend dented links back into the correct position before installing the ventilation duct.
4
5
1
3
2