Siemens NXAIR - Operating the Circuit-Breaker Panel; Control Elements at the Front Side of the Panel

Unloading and erection
110-0084.9 / 15 NXAIR / ≤ 40 kA 39
Attaching the crane rods
Depending on the panel version, the crane rods are attached differently.
The following examples show the basic attachment of the crane rods. For further information, see information
drawings NXAIR, order number 110-2300.9.
Fig. 35: Crane rods at the front and rear Fig. 36: Crane rods at the side
The two crane rods can be pushed into the craning angles at the front and rear on all panels. Depending on
the panel version, it is also possible to push the crane rods in at the side of the panel.
Pull out the locking cotter pin, remove the washer, and push the crane rod through the craning
angles at the panel. Then, slide the washer onto the crane rod again, and fit the locking cotter
pin.
If required, move the crane rod until protrusion A is the same at both ends of the crane rods.
Check protrusion A at the ends of the crane rods: > 300 mm.