Installation
22 SICAM RTUs, SICAM AK 3 User Manual
Edition 07.2016, DC2-028-2.03
1.2 Board Rack Installation
1.2.1 Installation Location
The system SICAM AK 3 can be used for the installation in a cabinet.
Systems, which use a CM-2846 board rack, are primarily designed for the 19" (swing-) frame
installation, but can optionally be expanded for rear panel installation.
Systems, which use a CM-2844 board rack, are designed for the rear panel installation.
Note:
The system SICAM AK 3 may only be installed horizontally.
1.2.2 Space Requirement
Certain minimum distances must be observed between board rack and adjacent equipment.
These minimum distances serve the installation and removal of components, the cabling and
the ventilation of the device in operation.
To Next Page
Loading...
