8 Operation at Use of a PC
8.3 Configuration of the Device
147SICAM Q100, 7KG95xx, Device Manual
E50417-H1040-C522-A4, Edition 03.2018
Parameterization of the Binary Outputs G1/G2 and G3/G2
To change the outputs of a binary output, proceed as follows:
✧ In the navigation window, select the Operational parameters menu, then the Process connections
submenu and click Binary outputs.
Figure 8-27 Configure Tab, Binary Outputs Input/Output Window
NOTE
The parameterization of both binary outputs is identical. Figure 8-27 depicts binary output Terminal G1/G2 as
output for indications and binary output Terminal G3/G2 as energy counter.
You can only set either an indication or
an energy counter for a binary output.
To Next Page
Loading...
