Siemens SIMATIC FM 351 - Page 199

Index
Index-3
FM 351 Positioning Module
C79000-G7076-C351-02
Incremental approach mode
sequence with incremental dimension
number 1–100, 9-18
sequence with incremental dimension
number 254, 9-18
sequence with incremental dimension
number 255, 9-19
Incremental dimension number 1–100, 9-18
Incremental dimension number 254, 8-25, 9-18
Incremental dimension number 255, 8-26, 9-19
Incremental dimension table errors, C-22
Incremental dimension tables, writing, 8-3
Incremental dimensions, 8-1, 8-24
Incremental encoder
increments per encoder revolution, 8-16
missing pulses, 8-18
reaction times, 10-3
signal shapes, 10-2
Incremental encoders, 10-2
Incremental mode, 9-17
Increments per encoder revolution, 8-16
Initial parameter assignment
incremental dimension tables, 8-3
machine data, 8-2
Installation, 3-1, 3-2, 5-2
Installation instructions, A-2
Installation of the rail, 3-1
Installing, 5-1
Installing the configuration package, 5-1
J
Job execution, order, 6-7
Job management for FC ABS_CTRL, C-7
Job status, 6-9
Jobs, 6-6
Jogging, 9-8
Jogging mode, sequence, 9-8
L
LED ”SF”, 11-3
LED CH 1, 11-3
LED CH 2, 11-3
Linear axis, 8-12
Load circuit, 4-7
Load power supply, 4-5
Location of the fictitious target, 9-28
Loop traverse, 9-27
sequence, 9-27
M
Machine data, 8-1
activating, 8-2
axis, 8-12
baud rate, 8-17
count direction, 8-17
distance per encoder revolution, 8-15
encoder, 8-15
encoder type, 8-15
frame length, 8-15
increments per encoder revolution, 8-16
monitoring functions, 8-18
number of encoder revolutions, 8-16
reading, 8-3
writing, 8-2
Machine data error, C-19
Machine data for the drive, 8-6
Machine data of the encoder, data in the
parameter DB, 8-15
Mark, CE, iv
Maximum cable length, 8-17
Messages, C-22
Missing pulses, incremental encoder, 8-18
Modifying incremental dimension tables, 8-3
Modifying machine data, 8-2
Module cycle, 6-15
Module data, fast access, 6-17
MON_FRAME, 8-18
MON_PULSE, 8-18
MON_WIRE, 8-18
Monitoring functions, 8-18, 9-2
Monitoring time, 8-11, 9-3, 9-4, 9-5
Motor circuit-breaker, 4-1
Multiturn encoder, 10-4, 10-4
frame length , range of values, 10-4
N
NO_REV, 8-16
O
Operating errors, C-15
Operating mode incremental, 9-17
Operating mode jogging, 9-8
Operator errors, C-16
Output signal
asymmetric, 10-2
symmetric, 10-2