Operation
7.2 Monitoring
LOGO! CMR2020 / LOGO! CMR2040
112 Operating Instructions, 09/2014, C79000-G8976-C356-01
If you click the "Apply" button, all the settings you made in the "Assignments" tab are
adopted and displayed in the list.
Note
The monitoring of the event only becomes active with the assignment event → action
1.
You have configured message texts, signal definitions, events and actions.
Assign the event to an action.
Select the "Activate assignment" check box.
With this, you activate the assignment for monitoring.
With the assignment of an action to an event, the relevant event is only monitored when
this assignment is active.
1. In the lower part of the page, click the "Add" button.
2. Following this, you will see three blocks with input boxes, drop-down lists, check boxes
and grayed out text boxes for the configuration.
Name
● Freely selectable symbolic name for this assignment.
● Activate/deactivate the assignment in the "Activate assignment" check box.
Event
● From the drop-down list, select the entry of the event you have created.
The entry is displayed with the symbolic name you assigned.
The grayed out boxes "Signal name", "Signal definition", "Event definition" show you
which event with the information shown will be used as the "If condition":
– Signal name
You have already made the setting in the Signal definitions (Page 103) tab:
Display of the symbolic name you assigned for a signal definition.
– Signal definition
You have already made the setting in the Signal definitions (Page 103) tab:
Display of the signal (signal source, signal type) that you are using under the symbolic
name you selected.
– Event definition
You have already made the setting in the Events (Page 105) tab:
Display of the event that you defined. The name originates from the "Event definition"
column.
To Next Page
Loading...
