Operation
7.2 Monitoring
LOGO! CMR2020 / LOGO! CMR2040
100 Operating Instructions, 09/2014, C79000-G8976-C356-01
LOGO! BM
Establishing communication between IBM and CMR
Figure 7-7 Monitoring - "LOGO! BM" tab
1. Enter the IP address of your BM in the "IP address of the LOGO! BM" input box.
2. Select the "Active" check box. This establishes a connection between the CMR and BM.
If the check box is disabled, there is no connection between the CMR and BM.
3. Then click the "Apply" button. The settings you have made are applied.
4. Click the "Ping LOGO! BM" button:
You test whether the entered IP address can be reached by the CMR. A message is
displayed indicating whether or not the IP address can be reached.
● With the "Query interval for process image" setting you specify the intervals (selection: "1
second" and "10 seconds") at which the process image of the BM will be read by the
CMR:
The CMR keeps a copy of the current process image and on request sends the process
image as a reply SMS message: see SMS commands (Page 122) and Reply SMS
message to the "MONITOR?" command (Page 127).
If you click the "Apply" button, all the settings you made in the "LOGO! BM" tab are adopted.
To Next Page
Loading...
