Configuration
6.4 System
LOGO! CMR2020 / LOGO! CMR2040
56 Operating Instructions, 09/2014, C79000-G8976-C356-01
Figure 6-2 System – "General" tab
Enter any name for your module.
Only use a DNS-compliant name as the module name. DNS-compliant names are, for
example, used for diagnostics.
Enter any name for your plant.
End session after inactive period (minutes)
If you are no longer working with the WBM, set the time after which your session will be
forced to close.
You then need to log in again with a user name and password.
Note
A maximum of 2 simultaneous logins (sessions) are possible. Both sessions have full write
access. Only the "Firmware update" and "Load configuration" functions can only be used
from w
ithin one session.
To Next Page
Loading...
