Operation
7.2 Monitoring
LOGO! CMR2020 / LOGO! CMR2040
Operating Instructions, 09/2014, C79000-G8976-C356-01
109
1. In the list, select the row with the action you want to modify.
2. Change the action with "Change action" in the lower part of the page.
Result: If you click the "Apply" button, your modified action is adopted and displayed in the
list.
Forwarding GPS position data to LOGO! BM
You can select the transfer of the current GPS position data to LOGO! BM as an action.
Triggering events can, for example be the expiry of a timer or the status change of a BM or
CMR input.
The basic sequence for configuration remains unchanged:
1. Configure LOGO! BM settings
2. Configure signal
3. Configure event
4. Configure action with the destination "LOGO! BM"" and the target element "GPS position"
5. Configure assignment
The start address at which the GPS position data is stored in the VM of the LOGO! BM must
be in the range 0 to 112.
Figure 7-12 Monitoring – "Actions" tab: Forwarding GPS position to LOGO! BM
To Next Page
Loading...
