Operation
7.1 Users / groups
LOGO! CMR2020 / LOGO! CMR2040
88 Operating Instructions, 09/2014, C79000-G8976-C356-01
In the following figure, select the block B007 from your control program with the
stopwatch function.
Figure 7-2 Variable Memory Configuration
3. Within the B007 block then select a variable to be monitored.
4. By clicking the "OK" button, you confirm your selection.
The selected variable is transferred to the VM.
The "Type" and "Address" of the selected variable are displayed in the VM.
For further details, refer to the LOGO! Soft Comfort description.
With the "Address" and "Type" parameters in the relevant SMS message, you can read and
write the status of the variables using SMS (Page 122).
You can enter a maximum of 20 users in the CMR:
● Assign attributes to every user: Description, name, phone number and much more.
● You set up recipient groups by distributing the users you have entered:
– Note that you can configure a maximum of five recipient groups with a maximum of
ten users.
– Recipient groups must not consist of only one recipient.
To Next Page
Loading...
