Installation, connecting up, commissioning
4.5 Mounting
LOGO! CMR2020 / LOGO! CMR2040
Operating Instructions, 09/2014, C79000-G8976-C356-01
31
To mount the CMR on a DIN rail, follow the steps below:
1. Fit the upper part of the locking mechanism
① of the device on to the DIN rail.
2. Press the device down against the DIN rail until the spring catch
② locks in place.
To remove the CMR from a DIN rail, follow the steps below:
1. Using a screwdriver, pull down the spring catch on the rear of the device
③.
2. Remove the device from the DIN rail.
To mount the CMR on a wall, follow the steps below:
1. Using a screwdriver, pull the two spring catches
① on the rear of the device towards the
outside.
2. Feed the screws through the openings in the catches and secure the device to the wall.
To Next Page
Loading...
