Installation, connecting up, commissioning
4.7 Insert the SIM card and enter the PIN
LOGO! CMR2020 / LOGO! CMR2040
34 Operating Instructions, 09/2014, C79000-G8976-C356-01
6. Restart the CMR by connecting up the power supply.
7. In the WBM, in "WAN", "Mobile wireless settings" tab, select the "Activate mobile wireless
interface" check box:
The mobile wireless interface is once again ready for operation.
8. Enter the PIN of your SIM card in WBM in the "WAN", Mobile wireless settings" tab.
Note
Entry of an incorrect PIN
The last entered (incorrect) PIN is saved. This means that when changing the
configuration (except the PIN) or when restarting the CMR, no further PIN entry attempt is
used up.
his reason, do not change the PIN of the SIM card to the previously stored incorrect
9. Click the "Apply" button: the PIN of your SIM card is adopted.
10.Make the appropriate settings (Page 47).
If you enter the PIN incorrectly three times, the SIM card will be locked.
Unblock the SIM card as follows:
1. Shut the CMR down to the safe status: "Turning off the CMR" (Page 26).
2. Disconnect the CMR from the power supply.
3. Remove the SIM card and close the compartment.
To remove the SIM card, press the left-hand sunken ejector button with a sharp object.
4. Insert the removed SIM card in a mobile phone.
5. Unblock the SIM card by entering the PUK or the SuperPIN.
You will have received the PUK or SuperPIN from your mobile wireless provider along
with the SIM card.
Result: The SIM card is unblocked and can be used again.
To Next Page
Loading...
