Commissioning
7.3 Connecting and setting up the reader using the PST
SIMATIC MV500
Operating Instructions, 06/2018, C79000-G8976-C494-01
93
Step 4: Start Web Based Management (WBM)
Follow the steps below to start the WBM:
1. Start your Internet browser.
2. Enter the IP address of the reader in the address bar of your browser.
3. Confirm your entry by pressing the <Enter> key.
Reaction: The WBM of the reader opens.
Figure 7-2 The homepage of the WBM
You are connected to the reader and the reader can be operated via the WBM. Below, you
can perform the next steps to configure the reader and see initial read results.
To Next Page
Loading...
