Siemens SIMATIC NET SCALANCE SC-600 Configuration Manual

Configuring with Web Based Management
4.5 "Layer 2" menu
SCALANCE SC-600 Web Based Management (WBM)
238 Configuration Manual, 10/2021, C79000-G8976-C475-03
Restoring factory settings
If you have restored the factory defaults, ring redundancy is disabled and the default
ports are used as the ring ports. This can lead to circulating frames and failure of the
data traffic if other settings were used in a previous configuration.
4.5.5 Spanning Tree
4.5.5.1 General
General settings of the Spanning Tree protocol
On this page, you can enable Spanning Tree and select the protocol compatibility. By
default, the "Spanning Tree Protocol" (STP) is enabled.
Description of the displayed boxes
The page contains the following boxes:
• Spanning Tree
Enable or disable Spanning Tree.
Note
No operation of Spanning Tree with enabled ring redundancy
If ring redundancy is enabled under "Layer 2", Spanning Tree cannot be used.
• Protocol Compatibility
Select the protocol compatibility. The following settings are available:
– STP
– RSTP

Siemens SIMATIC NET SCALANCE SC-600 Specifications

General

Brand	Siemens
Model	SIMATIC NET SCALANCE SC-600
Category	Switch
Language	English