Siemens SIMATIC NET SCALANCE SC-600 Configuration Manual

Configuring with Web Based Management
4.5 "Layer 2" menu
SCALANCE SC-600 Web Based Management (WBM)
252 Configuration Manual, 10/2021, C79000-G8976-C475-03
Enabling access control for all ports
1. In the "Setting" drop-down list in Table 1, select the "Enabled" entry.
2. Click the "Copy to Table" button. The check box is enabled for all ports in table 2.
3. To apply the changes, click the "Set Values" button.
4.5.8.3 Blocking
Blocking forwarding of unknown unicast frames
On this page, you can block the forwarding of unknown unicast frames for individual
ports.
Description of the displayed values
Table 1 has the following columns:
• 1st column
Shows that the settings are valid for all ports of table 2.
• Setting
Select the setting from the drop-down list. You have the following setting options:
– Enabled
Blocking of unicast frames is enabled.
– Disabled
Blocking of unicast frames is disabled.
– No change
Table 2 remains unchanged.
• Copy to Table
If you click the button, the setting is adopted for all ports of table 2.

Siemens SIMATIC NET SCALANCE SC-600 Specifications

General

Brand	Siemens
Model	SIMATIC NET SCALANCE SC-600
Category	Switch
Language	English