Siemens SIMATIC RF615R - Reader_Status

Programming via Rockwell controller
9.5 Programming add-on instructions
SIMATIC RF600
Configuration Manual, 11/2018, C79000-G8976-C386-07
117
9.5.1.5
Reader_Status
The "Reader_Status" block reads status information from the reader. For the RF68xR
reader, there is only the status mode "0x89" that is selected using the "ATTRIBUTE"
parameter. The status data is returned as "Array of Byte".
Figure 9-6 "Reader_Status" block
Table 9- 5 Explanation of the "Reader_Status" block
Parameter
Data type
Default values
Description
ATTRIBUTE SINT B#16#81 Identifier of the status mode "0x89"
Note: The default value is not valid for
RF680R/RF685R and needs to be
adapted.
IDENT_DATA SINT[10] 0 Event values depending on attributes
Note.
When necessary a byte/array of any
size can be transferred to this parame-
ter. Note that the array must be ≥ 10
bytes long (e.g. "SINT[12400]").
Results
Table 9- 6 ATTRIBUTE "0x89" ("IID_READER_STATUS_89_RF68xR" data type)
Name
Type
Comment
status_info
BYTE
SLG-Status mode(Subcommand)
hardware_version
BYTE
Version of hardware
firmware_version
ARRAY[1..4] of
CHAR
Version of firmware
config ID
DWORD
Unix timestamp
inventory_status
WORD
0=inventory not active;1=inventory active;2=presence
mode active
sum of filtered tags
WORD
All filtered Tags
filtered_smoothing
WORD
Filtered Tags trough Smoothing
filtered_blacklist
WORD
Filtered Tags trough Blacklist
filtered data-filter
WORD
Filtered Tags trough Data-Filter
filtered RSSI thresold
WORD
Filtered Tags trough RSSI Threshold
filtered RSSI delta
WORD
Filtered Tags trough RSSI Delta