Programming via Rockwell controller
9.5 Programming add-on instructions
SIMATIC RF600
124 Configuration Manual, 11/2018, C79000-G8976-C386-07
EPCID_UID SINT[62] 0 Buffer for up to 62 bytes EPC-ID, 8
bytes UID or 4 bytes handle ID.
• 2 - 62-byte EPC-ID is entered at
the start of the buffer (length is set
by "LEN_ID")
• 8-byte UID is entered at the start
of the buffer ("LEN_ID = 8")
• 4-byte handle ID must be entered
in the array element [5]-[8]
("LEN_ID = 8")
Default value: 0x00 ≙ unspecified
single tag access (RF620R, RF630R,
IDENT_DATA SINT[10] 0 Data buffer in which the read EPC
memory data is stored.
Note.
When necessary a byte/array of any
size can be transferred to this parame-
ter. Note that the array must be ≥ 10
bytes long (e.g. "SINT[12400]").
With the "Set_Param" block, you can change UHF parameters on an RF680R/RF685R
during runtime (e.g. the antenna power).
Note
Settings saved only temporarily
Note that the parameters in the "Set_Param" block are only stored temporarily. If the power
for the reader is interrupted, the stored values
are lost and must be set again.
Figure 9-11 "Set_Param" block
To Next Page
Loading...
