Programming via XML interface
10.4 XML EventReports
SIMATIC RF600
Configuration Manual, 11/2018, C79000-G8976-C386-07
215
0xE7 231 ERROR_READ_COMMAND_
FAILED
The read command failed.
0xE8 232 ERROR_WRITE_COMMAND_
The write command failed.
0xE9 233 ERROR_WRITETAGID_COMMAND_
Writing the EPC-ID failed.
0xEA 234 ERROR_LOCK_COMMAND_
The Lock command failed.
0xEB 235 ERROR_KILL_COMMAND_
The Kill command failed.
0xFA7 4007 ERROR_READPOINT_NOT_FOUND The specified read point is inactive because
it was not assigned to any antenna.
This section describes all the frames that can be sent by the reader to the user application
(XML reports). The reports can be transferred reliably or without verification. You will find
more information on XML reports in the section "Functionality of the XML interface
(Page 137)".
This section describes all events. Events are asynchronous messages sent by the reader
containing data acquired by the reader itself.
A triggered read point acquires transponder data that is sent to the user application with a
tag event report.
The configuration of the trigger (continuous, I/O level, ...) and the definition of the
transponder data (tag fields, RSSI value, ...) to be sent are taken from the stored
configuration. These parameters cannot only be changed using the WBM.
The transponder data in every event report is grouped according to the read points.
A reply frame from the user application is necessary only when secure mode is set. A reply
frame can, however, also be sent in non-secure mode and this has no negative influence.
To Next Page
Loading...
