Siemens SIMATIC RF615R - 1 Introduction

SIMATIC RF600
Configuration Manual, 11/2018, C79000-G8976-C386-07
7
Introduction
1
Purpose of this document
This manual contains all the information required for the parameter assignment and
commissioning of the SIMATIC RF615R, RF650R, RF680R and RF685R readers of the
SIMATIC RF600 system.
This manual is intended for:
● Commissioning engineers
● Configuration engineers
● Service technicians
Scope of validity of this document
This documentation is valid for all supplied versions of the SIMATIC
RF615R/RF650R/RF680R/RF685R readers and describes the delivery state as of 11/2018
and firmware version V3.1 or V3.2 for RF615R.
Registered trademarks
SIMATIC
®
, SIMATIC RF
®
, MOBY
®
, RF MANAGER
®
and SIMATIC Sensors
®
are registered
trademarks of Siemens AG.
Documentation classification
You will find additional information on the properties, technical specifications and possible
applications of the RF600 readers in the "SIMATIC RF600 System Manual
(https://support.industry.siemens.com/cs/ww/en/view/22437600
)".
You will find more information on operating the readers via communications modules
(PROFIBUS operation) in the manuals of the relevant communications module
(https://support.industry.siemens.com/cs/ww/en/ps/15105/man
).
You will find further information on the Ident profile and Ident blocks based on the "Proxy
Ident Function Block" protocol and described in this manual in the manual "Ident profile and
Ident blocks, standard function for Ident systems
(https://support.industry.siemens.com/cs/ww/en/ps/14971/man
)".
For S7 programmers who create their own command and acknowledgment frames, the
communications rules and frames that are required can be found in the Appendix in the
section "Command and acknowledgement frames (Page 276)". XML programmers will find
the required communications rules and frames in the section "Programming via XML
interface (Page 137)".