Siemens SIMATIC RF615R - Getreaderstatus

Programming via XML interface
10.3 XML commands
SIMATIC RF600
168 Configuration Manual, 11/2018, C79000-G8976-C386-07
10.3.2.14
getReaderStatus
This command requests status information from the reader.
Command
<frame>
<cmd>
<id> value_id </id>
<getReaderStatus/>
</cmd>
</frame>
Reply
<frame>
<reply>
<id> value_id </id>
<resultCode> 0 </resultCode>
<getReaderStatus>
<returnValue>
<readerType> value_readerType </readerType>
<mLFB> value_mLFB </mLFB>
<hWVersion> value_hWVersion </hWVersion>
<fWVersion> value_fWVersion </fWVersion>
<subVersions> // opt
<version> value_version </version>
…
</subVersion> // opt
</returnValue>
</getReaderStatus>
</reply>
</frame>
// opt → Optional: Line can be omitted.
The error codes for negative replies ("resultCode" ≠ 0) are described in the section "Negative
XML replies (Page 213)".