Programming via Rockwell controller
9.7 Digital inputs/outputs
SIMATIC RF600
Configuration Manual, 11/2018, C79000-G8976-C386-07
135
The sending of chained commands with Rockwell controllers functions in exactly the same
was as with S7 controllers. You will find a description of how commands are chained in the
section "Chaining" in the manual "Ident profile and Ident blocks, standard function for Ident
systems (https://support.industry.siemens.com/cs/ww/en/ps/14971/man
)".
The Ident profile supports command repetition (Repeat command). Command repetition with
Rockwell controllers functions in exactly the same was as with S7 controllers. You will find a
description of command repetition in the section "Command repetition" in the manual "Ident
profile and Ident blocks, standard function for Ident systems
(https://support.industry.siemens.com/cs/ww/en/ps/14971/man
)".
The structure and the way digital inputs/outputs work with Rockwell controllers is identical to
the structure and the way they work with S7 controllers. You will find a description of digital
inputs/outputs in the section "Digital inputs/outputs (Page 105)".
To Next Page
Loading...
