Siemens SIMATIC RF615R - Triggersource

Programming via XML interface
10.3 XML commands
SIMATIC RF600
Configuration Manual, 11/2018, C79000-G8976-C386-07
175
Parameter
Parameter
Type
Values
Description
value_id Decimal value
0...9
0...4294967295 Unique command identifier
value_
sourceName
Text -- Read point name
The name is specified using the WBM
(refer to the section "The "Settings -
Read points" menu item (Page 52
)").
In the standard configuration, there is
only one read point with the name
"Readpoint_1".
value_tagID Hexadecimal
value
0...9, A...F
-- EPC-ID in "RAW Hex Data Format"
Example of a 96-bit EPC-ID:
3005FB63AC1F3681EC880468
For additional information, refer to the
"EPC Global Specification".
10.3.3.3
triggerSource
Triggering the read point to trigger inventories. In this case, identified transponders are
subjected to the smoothing algorithm and can have the statuses "GLIMPSED",
"OBSERVED" and "LOST". The data of the identified statuses is sent to the user application
as a "TagEventReport".
The configuration parameters of the read point such as "Smoothing" and the definition of the
data of each transponder (tag fields, RSSI value, ...) to be sent are taken from the stored
configuration. You set this parameter in the WBM. You will find more information on
parameters in the section "The "Settings - Read points" menu item (Page 52)".
Command
<frame>
<cmd>
<id> value_id </id>
<triggerSource>
<sourceName> value_sourceName </sourceName>
<triggerMode> value_triggerMode </triggerMode> // opt
</triggerSource>
</cmd>
</frame>
// opt → Optional: Line can be omitted.