Configuration via STEP 7 (PROFINET device)
5.3 Overview of the configurable properties
SIMATIC RF600
34 Configuration Manual, 11/2018, C79000-G8976-C386-07
The reader is connected, has started up and a device name has been assigned to the
reader. The TIA Portal has been started.
Follow the steps below to create a new project:
1. Open the TIA Portal with "Start > All Programs > Siemens Automation > TIA Portal Vxx".
2. Create a new project.
3. Change to the Project view.
4. Using the project tree, insert a SIMATIC controller in the project with the "Add new
device" menu command.
The device view opens and the controller is displayed.
5. Go to the network view and drag the required reader type from the hardware catalog to
the project ("Detecting & Monitoring > Ident systems > PROFINET > SIMATIC RF600").
6. Connect the reader to the controller.
Note
Downloading the project
If you have already created an RF600 project, you can select this in the start view of the TIA
Portal and open it with the "Load p
roject" button.
Overview of the configurable properties
To display the reader properties, select the reader in the device view and open the
"Properties" tab.
Figure 5-1 Properties of the reader
To Next Page
Loading...
