Programming via XML interface
10.3 XML commands
SIMATIC RF600
214 Configuration Manual, 11/2018, C79000-G8976-C386-07
0x92 146 ERROR_WRONG_PASSWORD The password you entered is incorrect.
Access to the transponder was denied.
Verification of the transponder failed.
General transponder error.
0x95 149 ERROR_TAG_INSUFFICIENT_
There is not enough transponder power.
0x22 34 ERROR_TOO_MANY_TAGS There are too many transponders in the
0xA1 161 ERROR_NO_TAG There is no transponder with the relevant
EPC-ID in the antenna field.
The requested data is not available.
No radio channel activated.
No carrier signal activated.
0xA7 167 ERROR_MORE_THAN_ONE_
There is more than one transponder in the
0xA8 168 ERROR_AIR_PROTOCOL_
General radio protocol error
0x43 67 ERROR_ANTENNA An antenna error was detected during
command execution.
You can find additional information on an-
tenna errors and possible solutions in the
section "XML/PLC error messages
(Page 247)".
0x46 70 ERROR_INVALID_READER_
The specified command is not permitted in
the current reader status.
The specified tag field is unknown.
A general error has occurred.
A configuration error has occurred.
0x61 97 ERROR_COMMAND_NOT_
The command is not supported by the
0x63 99 ERROR_PARAMETER_INVALID_
A parameter has an invalid value.
0xE1 225 ERROR_PARAMETER_MISSING A necessary parameter has not been speci-
0xE2 226 ERROR_PARAMETER_INVALID_
A parameter has an incorrect format
0xE3 227 ERROR_PARAMETER_INVALID_
A parameter has the wrong format or the
0xE4 228 ERROR_PARAMETER_NOT_
A parameter is not supported by this reader.
0xE5 229 ERROR_WRONG_MESSAGE_
The XML format is incorrect. An error was
detected when parsing the command.
0xE6 230 ERROR_INVENTORY_COMMAND_
The inventory command failed.
To Next Page
Loading...
