Siemens SIMATIC RF615R - Page 160

Programming via XML interface
10.3 XML commands
SIMATIC RF600
160 Configuration Manual, 11/2018, C79000-G8976-C386-07
</getParameter>
</reply>
</frame>
The error codes for negative replies ("resultCode" ≠ 0) are described in the section "Negative
XML replies (Page 213)".
Parameter
Parameter
Type
Values
Description
value_id Decimal value
0...9
0...4294967295 Unique command identifier
value_name Alphanumeric text See following
table
Name of the supported parameter
value_value Alphanumeric text See following
table
Parameter value
value_objType Alphanumeric text See following
table
Specifies the type of the parameter
groups to be addressed.
value_objName Alphanumeric text See following
table
Name of the specific parameter group
Possible values of the "value_name" parameter
name
value
objType
objName
Description
Power 0, 5.00...33.00 Antenna Antenna01
Antenna02
Antenna03
Antenna04
Radiated power of the antenna
in [dB]
Increment: 0.25 dB
RssiThreshold 0...255 Antenna Antenna01
Antenna02
Antenna03
Antenna04
RSSI threshold value
Transponders with lower RSSI
values are not taken into ac-
count.
This is a value without a unit
and without direct reference to
the power strength.
Polarization Default
Circular
Linear_vertical
Linear_
horizontal
All
Antenna Antenna01
Antenna02
Antenna03
Antenna04
Polarization of the antenna
Currently, this parameter can
only be set for the internal an-
tenna of the RF685R.