Siemens SIMATIC RF615R - Page 171

Programming via XML interface
10.3 XML commands
SIMATIC RF600
Configuration Manual, 11/2018, C79000-G8976-C386-07
171
Reply
<frame>
<reply>
<id> value_id </id>
<resultCode> 0 </resultCode>
<getAllAntennas>
<returnValue>
<antennaName> value_antennaName </antennaName>
…
<antennaName> value_antennaName </antennaName> // opt
</returnValue>
</getReaderStatus>
</reply>
</frame>
// opt → Optional: Line can be omitted.
The error codes for negative replies ("resultCode" ≠ 0) are described in the section "Negative
XML replies (Page 213)".
Parameter
Parameter
Type
Values
Description
value_id Decimal value
0...9
0...4294967295 Unique command identifier
value_
source Name
Text -- Name of the read point The name is
set via the WBM (see section "The
"Settings - Read points" menu item
(Page 52
)"). In the standard configura-
tion, there is only one read point with
the name "Readpoint_1".
value_
antennaName
Fixed value Antenna01
Antenna02
Antenna03
Antenna04
Optional
Name of the antenna