Siemens SIMATIC RF615R - Page 178

Programming via XML interface
10.3 XML commands
SIMATIC RF600
178 Configuration Manual, 11/2018, C79000-G8976-C386-07
<tagID> value_tagID </tagID>
<tagPC> value_tagPC </tagPC> // opt
<utcTime> value_utcTime </utcTime> // opt
<antennaName> value_antennaName </antennaName> // opt
<rSSI> value_rSSI </rSSI> // opt
<channel> value_channel </channel> // opt
<power> value_power </power> // opt
<polarization> value_polarization </polarization> // opt
<inventoried> value_inventoried </inventoried> // opt
<filterDataAvailable> value_filterDataAvailable
</filterDataAvailable> // opt
</tag>
…
<tag> // opt
…
</tag> // opt
</returnValue>
</readTagIDs>
</reply>
</frame>
// opt → Optional: Line can be omitted. In the reply, the parameter is transferred depending
on the configuration settings (Settings - Communication).
The error codes for negative replies ("resultCode" ≠ 0) are described in the section "Negative
XML replies (Page 213)".
Parameter
Parameter
Type
Values
Description
value_id Decimal value
0...9
0...4294967295 Unique command identifier
value_
sourceName
Text -- Read point name
The name is specified using the WBM
(refer to the section "The "Settings -
Read points" menu item (Page 52
)").
In the standard configuration, there is
only one read point with the name
"Readpoint_1".
value_duration Decimal value
0...9
0...65535 Optional
Duration for which the selected read
point will read transponders.
If the value "0" is set or the parameter
is empty, only one read cycle is exe-
cuted.