Siemens SIMATIC RF615R - Page 196

Programming via XML interface
10.3 XML commands
SIMATIC RF600
196 Configuration Manual, 11/2018, C79000-G8976-C386-07
The reply frame contains the IDs of all identified transponders. A flag for each transponder
indicates whether or not the command was successful for this transponder.
If no transponder was identified, a negative reply is returned.
Command
<frame>
<cmd>
<id> value_id </id>
<readTagField>
<sourceName> value_sourceName </sourceName>
<tagID> value_tagID </tagID> // opt
<password> value_password </password> // opt
<tagField>
<fieldName> value_fieldName </fieldName>
</tagField>
…
<tagField> // opt
…
</tagField> // opt
</readTagField>
</cmd>
</frame>
// opt → Optional: Line can be omitted.
Reply
<frame>
<reply>
<id> value_id </id>
<resultCode> 0 </resultCode>
<readTagField>
<returnValue>
<tag>
<tagID> value_tagID </tagID>
<tagPC> value_tagPC </tagPC> // opt
<success> value_success </success>
<utcTime> value_utcTime </utcTime> // opt
<antennaName> value_antennaName </antennaName> // opt
<rSSI> value_rSSI </rSSI> // opt
<channel> value_channel </channel> // opt
<power> value_power </power> // opt
<polarization> value_polarization </polarization> // opt
<commandRetry> value_commandRetry </commandRetry> // opt
<airRetry> value_airRetry </airRetry> // opt
<filterDataAvailable> value_filterDataAva
ilable
</filterDataAvailable> // opt