Programming via XML interface
10.3 XML commands
SIMATIC RF600
208 Configuration Manual, 11/2018, C79000-G8976-C386-07
● The masking value specifies which action value bit is to be set as s/w as shown in the
table above ("skip/write" where "skip=0" and "write=1").
● The action value specifies which lock should be defined for each memory bank.
● The "r/w" flag locks the password for read and write access.
● The "w" flag locks the password for write access (read access permitted).
● The "p" flag specifies a permanent lock.
The following tables show possible combinations of the "r/w" and "w" flags with "p" flags and
the meaning of the combination for a memory bank.
The transponder is in the "open" status when it is identified and in the "secure" status when
its access password is verified.
Table 10- 3 Possible combinations of the "w" and "p" flags
0 0 Write access to the particular memory bank is possible from both the "open" and
0 1 Write access to the particular memory bank is permanently possible from both the
"open" and the "secure" status, it cannot be locked.
1 0 Write access to the particular memory bank is possible from the "secure" status but
not from the "open" status.
No write access to the particular memory bank is possible.
Table 10- 4 Possible combinations of the "r/w" and "p" flags
0 0 Read and write access to the particular password is possible from both the "open"
0 1 Read and write access to the particular password is permanently possible from
both the "open" and the "secure" status, it cannot be locked.
1 0 Read and write access to the particular password is possible from the "secure"
status but not from the "open" status.
No read or write access to the particular memory bank is possible.
To Next Page
Loading...
