Siemens SIMATIC RF615R - Page 210

Programming via XML interface
10.3 XML commands
SIMATIC RF600
210 Configuration Manual, 11/2018, C79000-G8976-C386-07
Reply
<frame>
<reply>
<id> value_id </id>
<resultCode> 0 </resultCode>
<lockTagBank>
<returnValue>
<tag>
<tagID> value_tagID </tagID>
<tagPC> value_tagPC </tagPC> // opt
<success> value_success </success>
<utcTime> value_utcTime </utcTime> // opt
<antennaName> value_antennaName </antennaName> // opt
<rSSI> value_rSSI </rSSI> // opt
<channel> value_channel </channel> // opt
<power> value_power </power> // opt
<polarization> value_polarization </polarization> // opt
<commandRetry> value_commandRetry </commandRetry> // opt
<airRetry> value_airRetry </airRetry> // opt
<filterDataAvailable> value_filterDataAvailable
</filterDataAvailable> // opt
</tag>
…
<tag> // opt
…
</tag> // opt
</returnValue>
</lockTagBank>
</reply>
</frame>
// opt → Optional: Line can be omitted. In the reply, the parameter is transferred depending
on the configuration settings (engineering/communication).
The error codes for negative replies ("resultCode" ≠ 0) are described in the section "Negative
XML replies (Page 213)".
Parameter
Parameter
Type
Values
Description
value_id Decimal value
0...9
0...4294967295 Unique command identifier.
value_
sourceName
Text -- Name of the read point.
The name is specified using the WBM
(refer to the section "The "Settings -
Read points" menu item (Page 52
)").
In the standard configuration, there is
only one read point with the name
"Readpoint_1".