Service and maintenance
13.3 Module replacement
SIMATIC RF600
Configuration Manual, 11/2018, C79000-G8976-C386-07
259
Backup into a STEP 7 project
From the device view of the TIA Portal, you can access the "Properties" tab of the reader.
When configuring with HSP, in the "Configuration management" entry, you can save the
configuration of the reader in your project and also load this on the reader again.
Figure 13-3 Backing up the configuration
● The "PROFINET interface [X1]" entry contains the correct IP address of the reader.
● The user name and corresponding password have been entered correctly.
● The entered user has the required rights to run the download/upload (refer to the section
"The "User management" menu item (Page 98)").
Note
User name and password only necessary if user management is enabled
The "User name" and "Password" text boxes only
need to be completed if the user
management of the WBM is enabled.
Following the upload/download, the status bar indicates whether the action was completed
successfully.
On the upper toolbar of the WBM, there are two buttons for loading and saving
configurations. Using these buttons, you can back up configurations, re-load them and
transfer them to other readers. You will find further information on saving and loading the
configuration on or from the PC in the section "The WBM (Page 41)".
Note
Loading a configuration
Note that you cannot transfer any user profiles and passwords to other readers using the
configuration file. After loading the configuration file on a new reader, you need to enable
user management and create new user profiles and passwords.
To Next Page
Loading...
