CPU display
Automation system
System Manual, 01/2023, A5E03461182-AK
293
Regarding ②: Names of the menus
The following table shows the available menus of the display.
Table 13- 2 Names of the menus
The "Overview" menu contains information about:
• The properties of the CPU
• The properties of the inserted SIMATIC Memory Card
• Whether a know-how protection or a linking of the serial number exists.
The following information is displayed for F-CPUs:
• The status of the safety mode
• The collective signature
• The date of the last changes
Diagnostics The "Diagnostics" menu includes:
• The display of diagnostic messages.
• Read/write access to force and watch tables.
• Display of cycle time.
• Display of CPU memory utilization.
• Display of interrupts.
In the "Settings" menu you:
• Assign the IP addresses and the PROFINET device name of the CPU.
• Set the network properties of each CPU interface.
• Set the date, time, time zones, operating modes (RUN/STOP) and protec-
tion levels.
• Disable/enable display with display password
• Perform a CPU memory reset.
• Perform a reset to factory settings.
• Format the SIMATIC Memory Card.
• Delete the user program.
• Back up/restore the CPU configuration to/from the SIMATIC Memory
Card.
• View the status of the firmware update.
• Convert the SIMATIC Memory Card to a program card
The "Modules" menu contains information about the central and distributed
modules that are used in your configuration.
Peripherally deployed modules are connected to the CPU via PROFINET
and/or PROFIBUS.
You can set the IP addresses for the CPU or a CP/CM here.
Fail-safe parameters are displayed for F-modules.
Display In the "Display" menu you can configure settings related to the display, such
as language setting, brightness and energy-saving mode. The energy-saving
mode dims the display. The standby mode selectors the display off.
To Next Page
Loading...
