Software section
3.1 Creating the project and hardware
S7-1500
Getting Started, 05/2014, A5E03981761-AC
41
Creating ET 200 interface modules
Introduction
In the following section, you will create two distributed I/O systems in the hardware
configuration:
● An ET 200SP distributed I/O system, which basically consists of the following
components:
– An interface module for communication with the CPU.
– Up to 32 modules that can be inserted in any combination.
– A server module that completes the configuration.
● An ET 200MP distributed I/O system, which consists of the following components:
– The interface module for communication with the CPU.
– Up to 30 modules, each one providing up to 32 channels.
1. Open the "Hardware catalog".
2. Change to the "Network view".
3. Open the "Distributed I/O" and "ET 200SP" folders.
4. Open the "IM 155-6 PN ST" folder.
5. Drag-and-drop the "6ES7 155-6AU00-0BN0" interface module to the network view.
6. Open the "ET 200MP" folder.
7. Open the "IM 155-5 PN ST" folder.
8. Drag-and-drop the "6ES7 155-5AA00-0AB0" interface module to the network view.
To Next Page
Loading...
Need help?
General
