System
8.1 "System" operating area
Cylindrical grinding
110 Programming and Operating Manual, 07/2009, 6FC5398-4CP10-2BA0
Resetting the credential
User network log-in
Use "Change language" to select the user interface language.
Figure 8-5 User interface language
Use the cursor keys to select the language and confirm it by pressing "OK".
Note
The HMI is automatically restarted when a new language is selected.
Use "Service language" to always select "English" as the user interface language.
Press the "Service language" softkey again to restore the previously active language (e. g.
"Simpl. Chinese").
Note
An asterisk "*" marks the languages you have used.
'HOHWH
SDVVZRUG
5&6
ORJLQ
&KDQJH
ODQJXDJH
6HUYLFH
ODQJXDJH
To Next Page
Loading...
Need help?
General
