Siemens SINUMERIK 828D Series User Manual

O
On-site service, 71
P
PPU 290.4, 24
PPU version horizontal, 25
PPU version vertical, 25
Protective conductor connection, 122
R
Removing MCP 310 USB, 93
Removing MCP 310C PN, 104
Removing MCP 483 USB, 93
Removing MCP 483C PN, 100
Removing the MCP Interface PN, 96
Rotary switch
Replacing, 107
S
S120 Combi
Cleaning the heat sink, 162
DC link cover, 146
Drip protection, 144
installing an internal fan, 157
Remove the air baffle plate, 162
Removing the internal fan, 154
Spare parts, 238
Safety instructions
S120 Combi, 145
Terminal Module TM120, 225
Service contact person, 27
Shield contact, 122
Spare parts, S120 Combi, 238
Switch
S1 on the I/O module, 113, 117
S2 on the MCP 310C PN, 107
S2 on the MCP 483C PN, 102
T
Technical support, 27
U
USB FlashDrive, 52, 237
W
Web License Manager, 64
Index
Software and hardware
246 Service Manual, 08/2018, 6FC5397-5DP40-6BA1

Siemens SINUMERIK 828D Series Specifications

General

Display	10.4" TFT color display
Operating System	Embedded Linux
Power Supply	24V DC
Protection Class	IP65 (front), IP20 (rear)
Control Unit Type	CNC
Interfaces	Ethernet, USB, RS232
Programming	ShopMill, ShopTurn, G-code