Siemens SINUMERIK 828D Series User Manual

Procedure
To load the manual data backup (via the "Back up data" softkey), proceed as follows:
1. The following display is shown when booting after power-on:
2. To start the Startup menu press the <SELECT> key.
You now go to the Startup menu:
Service cases - software
3.1 Backing up user data
Software and hardware
Service Manual, 08/2018, 6FC5397-5DP40-6BA1 33

Siemens SINUMERIK 828D Series Specifications

General

Display	10.4" TFT color display
Operating System	Embedded Linux
Power Supply	24V DC
Protection Class	IP65 (front), IP20 (rear)
Control Unit Type	CNC
Interfaces	Ethernet, USB, RS232
Programming	ShopMill, ShopTurn, G-code