Siemens SINUMERIK 828D Series User Manual

3. Using the arrow key, select the menu item "Reload saved user data".
4. Confirm that the backup is loaded by pressing the key <INPUT>.
5. Confirm the confirmation prompt by pressing the <INPUT> key.
Are you sure you want to reload saved user data?"
Note
Booting
If data is lost from the buffer memory, the data saved in the permanent memory will
automatically be reloaded to the memory at POWER ON.
If the control boots with the backed-up data, the following message is displayed:
"4062 Data backup copy has been loaded".
Service cases - software
3.1 Backing up user data
Software and hardware
34 Service Manual, 08/2018, 6FC5397-5DP40-6BA1

Siemens SINUMERIK 828D Series Specifications

General

Display	10.4" TFT color display
Operating System	Embedded Linux
Power Supply	24V DC
Protection Class	IP65 (front), IP20 (rear)
Control Unit Type	CNC
Interfaces	Ethernet, USB, RS232
Programming	ShopMill, ShopTurn, G-code