Siemens SINUMERIK 828D Service Manual

Service cases - hardware
4.3 SINAUT modem
Hardware and Software
Service Manual, 03/2011, 6FC5397-5DP40-0BA0
87
Inserting the SIM card
NOTICE
When handling SIM cards, carefully observe its safety instructions.
When changing the SIM card, do not forget to change the PIN in your control.
If you are using a lot of SIM cards, it may make sense to set all SIM cards, e.g. with one
cellular phone to the same PIN.
Proceed as follows to insert the SIM card:
1. Using your fingernail or a suitable object, slide the upper section of the SIM card holder
approximately 2 mm in the direction of the arrow to the left so that the upper section can
be flipped up.
2. Flip up the upper section of the SIM card holder so that you can insert the SIM card into
this section.

Siemens SINUMERIK 828D Specifications

General

Control Type	CNC
Operating System	Windows Embedded
Processor	Intel Atom
Display	10.4" color TFT display
Interfaces	Ethernet, USB
Programming	ShopMill, ShopTurn
Operation Panel Size	10.4"
Protection Class	IP65
PLC Memory	2 MB
Spindle Capacity	4 spindles
Hard Drive	CompactFlash