06.03
5.3 Default address assignment
5-139
 Siemens AG, 2003. All rights reserved
SINUMERIK 840Di Manual (HBI) – 06.03 Edition
5.3 Default address assignment
The following figure 5-2 shows a SINUMERIK 840Di with the user interface run-
ning on the PCU:
S 840Di start-up or HMI Advanced
and the further components connected on the MPI bus:
S Machine control panel (MCP) or interface customer operator panel
S Handheld terminal (HT 6)
S SIMATIC programming device PG 740
with standard assignment of the MPI addresses.
NC
PLC
MCP/interface
customer operator
panel
3
6
Address at MPI bus
SINUMERIK 840Di
(PCU with MCI board)
PG 740
0
2
840Di-start-up/
HMI Advanced
1
MPI bus
X
HT 6
14
Fig. 5-2 Default addresses at the MPI bus with SINUMERIK 840Di
Standard MPI
addresses
5 MPI Communication
To Next Page
Loading...
Need help?
General
