Siemens SINUMERIK 840Di - I;O Module PP72;48

06.03
2.12I/O Module PP72/48
2-93
 Siemens AG, 2003. All rights reserved
SINUMERIK 840Di Manual (HBI) – 06.03 Edition
2.12 I/O Module PP72/48
2.12.1 Module
X111
X222
X333
X1: Power supply
X2: PROFIBUS
S1: DIL switch for setting the
PROFIBUS address
LED: OVTEMPLED: POWER
LED: EXCHANGELED: READY
Dig. input/outputs
(50-pin ribbon cable connector)
ON
1
8
OFF
Fig. 2-29 I/O Module PP72/48
Designation Order No. (MLFB)
I/O Module PP72/48 6FC5 611-0CA01-0AA0
The I/O module PP72/48 is a simple and low-cost module (without a separate
housing) for connecting digital input/outputs as part of an automation system
based on PROFIBUS DP.
The module has the following important features:
S PROFIBUS DP connection (max. 12 Mbaud), specified by:
PROFIDrive profile drive technology version 3,
Draft V1.4.2, 01. September 00
S 72 digital inputs and 48 digital outputs
S On-board status display by means of four diagnostic LEDs
To power the module and the digital outputs, an external power supply source
(+24VDC) is required.
Order number
Features
2 Hardware Descri
p
tions