Siemens SINUMERIK 840Di - Axis Names

06.03
10.5 Axes and spindles
10-311
 Siemens AG, 2003. All rights reserved
SINUMERIK 840Di Manual (HBI) – 06.03 Edition
Table 10-16 Axis configuration: Machine data
Number Identifier Name/remarks Ref.
General ($MN_ ...)
13050 DRIVE_LOGIC_ADDRESS I/O address of drive
Channel-specific ($MC_ ...)
20050 AXCONF_GEOAX_ASSIGN_TAB Assignment of geometry axis to channel axis
20070 AXCONF_MACHAX_USED Machine axis number valid in channel
Axis-specific ($MA_ ...)
30110 CTRLOUT_MODULE_NR Setpoint assignment
30220 ENC_MODULE_NR Actual-value assignment
/FB/ Description of Functions, Basic Machine,
K2 Axes, Coordinate Systems, Frames, Actual-Value System for
Workpiece IWS, Section: Axes
10.5.2 Axis names
Each machine, channel and geometry axis can/must be assigned an individual
name unambiguously identifying it in its name range.
The machine data
 MD10000: AXCONF_MACHAX_NAME_TAB [n] (machine axis name)
is used to define the machine axis names.
Machine axis names must be unambiguous for the entire NC.
The names and the corresponding index defined in the machine data above is
used for
 accessing axis-specific machine data (loading, saving, displaying)
 reference point approach from the parts program G74
 measuring
 test point traversing from the parts program G75
 traversing the machine axis from PLC
 display of axis-specific alarms
 display in the actual-value system (machine-related)
 DRF handwheel function.
Machine data
References
Machine axes
10 NC Start-U
p
with HMI Advanced