Siemens SINUMERIK 840Di - Monitoring Functions of Axis

06.03
10.5 Axes and spindles
10-343
 Siemens AG, 2003. All rights reserved
SINUMERIK 840Di Manual (HBI) – 06.03 Edition
10.5.18 Monitoring functions of axis
The static monitoring functions with reference to a machine axis are:
Window around the setpoint position within which exact stop coarse is detected.
 MD36000: STOP_LIMIT_COARSE (exact stop coarse)
 IS: DB31,... DBX60.6 (position reached with exact stop coarse).
Window around the setpoint position within which exact stop fine is detected.
 MD 36010: STOP_LIMIT_FINE (exact stop fine)
 IS: DB31,... DBX60.7 (position reached with exact stop coarse).
Delay time after which the actual value must have reached the tolerance
window “Exact stop fine” when the setpoint position is reached.
 MD 36020: POSITIONING_TIME (exact stop fine delay time)
 Alarm: “25080 Positioning monitoring” and follow-up mode”.
Position tolerance which a standing machine axis may not leave.
 MD36030: STANDSTILL_POS_TOL (standstill position tolerance)
 Alarm: “25040 Zero speed control” and follow-up mode”.
Delay time after which the actual value must have reached the tolerance
window “Standstill position tolerance” when the setpoint position is reached.
 MD36040: STANDSTILL_DELAY_TIME (zero speed control delay time)
 Alarm: “25040 Zero speed control” and follow-up mode”.
Tolerance window for a standing machine axis while the signal “Clamping
process running” is present at the PLC interface.
 MD36050: CLAMP_POS_TOL (clamping tolerance)
 IS: DB31,... DBX2.3 (clamping process running)
 Alarm: “26000 Clamping monitoring”.
Static monitoring
functions
Exact stop coarse
Exact stop fine
Delay time
Exact stop fine
Standstill position
tolerance
Delay time
Zero speed control
Clamping tolerance
10 NC Start-U
p
with HMI Advanced