Siemens SINUMERIK 840Di - Page 342

06.03
10.5 Axes and spindles
10-342
 Siemens AG, 2003. All rights reserved
SINUMERIK 840Di Manual (HBI) – 06.03 Edition
Table 10-37 Velocities: Machine data
Number Identifier Name/remarks Ref.
Axis-specific ($MA_ ...)
30300
IS_ROT_AX[n]
Rotary axis
32000
MAX_AX_VELO[n]
Maximum axis velocity G2
32010
JOG_VELO_RAPID[n]
Conventional rapid traverse
32020
JOG_VELO[n]
Conventional axis velocity
32040
JOG_REV_VELO_RAPID[n]
Revolutions feedrate in JOG mode with rapid tra-
verse override
32050
JOG_REV_VELO[n]
Revolutional feedrate in JOG mode
32060 POS_AX_VELO Reset position for positioning axis velocity P2
32250 RATED_OUTVAL Rated output voltage
32260
RATED_VELO[n]
Rated motor speed
Table 10-38 Velocities: Setting data
Number Identifier Name/remarks Ref.
General ($SN_ ...)
41100 JOG_REV_IS_ACTIVE Revolutional feedrate in JOG mode active
41110 JOG_SET_VELO JOG velocity for linear axes (for G94)
41120 JOG_REV_SET_VELO JOG velocity (for G95)
41130 JOG_ROT_AX_SET_VELO JOG speed for rotary axes
41200 JOG_SPIND_SET_VELO JOG velocity for the spindle
/FB/ Description of Functions, Basic Machine,
G2 Velocities, Setpoint/Actual-Value Systems, Closed-Loop Control,
Section: Velocities, traversing Ranges, accuracies
/FB/ Description of Functions – Extended Functions,
H1JOG with/without handwheel
Machine data
Setting data
References
10 NC Start-U
p
with HMI Advanced