Siemens SINUMERIK 840Di - SINUMERIK Industrial PC

06.03
1.3 Notes on start-up
1-36
 Siemens AG, 2003. All rights reserved
SINUMERIK 840Di Manual (HBI) – 06.03 Edition
– for creating a SIMATIC S7 project to start up the SINUMERIK 840Di-
PLC, the MPI and PROFIBUS DP communication
– for installing additional software on the PCU.
S an MPI cable for connecting the PCU to the programming unit
Note
A programming device is not needed if:
– the SIMATIC Manager STEP7 is installed on the PCU of the SINUMERIK
840Di
– an existing PC is used to install additional software.
For installing software on the PCU, see Chapter 15, Page 15-455.
The following documentation is required for start-up:
S /BH/ Operator Components Manual
– SINUMERIK Operator Panels
– SINUMERIK Industrial PCs
– Machine Control Panels
– Handheld Operator and Programming Units.
Depending on the NC and PLC functions used, the relevant Descriptions of
Functions.
S /FB/ Description of Functions – Basic Machine
S /FB/ Description of Functions – Extended Functions
S /FB/ Description of Functions – Special Functions
The list of references in the Appendix provides an overview of the contents of
the individual Descriptions of Functions.
S /LIS/ Lists
– Overview of Functions
– Machine, Setting Data and Variables
– Interface Signals and PLC Blocks.
S /DA/ Diagnostics Guide, Contents:
– Alarms.
Documentation
1 General on the SINUMERIK 840Di