Siemens SINUMERIK 840Di - Creating a Series Machine Start-Up File Using HMI Advanced

06.03
14.2 Creating a series machine start-up file using HMI Advanced
14-451
 Siemens AG, 2003. All rights reserved
SINUMERIK 840Di Manual (HBI) – 06.03 Edition
14.2 Creating a series machine start-up file using HMI
Advanced
The creation of a series machine start-up file is divided into the following steps:
1. Open the menu to create a series machine start-up file:
Operating area switchover > Services > key:up “>” > Series machine
start-up > Create start-up archive
2. Select the contents and assign the file name
3. Create the series machine start-up file by selecting the device to which you
wish the file to be output
Note
Because of its file extension “.arc”, the series machine start-up file is also called
archive.
A series machine start-up file can be created for the following components:
S NC with/without compensation data
S PLC
S HMI
When selecting, any combinations are possible.
However, it is recommended to save the individual components separately in
separate series machine start-up files. It is thus possible to reload them inde-
pendently of each other and with maximum flexibility.
Note
Compensation data must only be archived if the series machine start-up file is
to be reloaded into the same control system (backup).
Selecting contents
14 User Data Backu
p
/Series Machine Start-U
p